Toolhead Camera Replacement Guide for the X2D
Bambu Lab X2D • Série Avançada X2
Toolhead Camera Replacement Guide for the X2D
Tip: The camera is designed for printer functions only. Please ensure the camera is correctly installed so that the camera field of view is correctly pointing towards the print area, to avoid any detection issues of the build plate or nozzles.
Toolhead camera
🔎 Find the X2D Toolhead camera in the Bambu Lab store.
The toolhead camera is installed on the right side of the toolhead and is used for motion accuracy calibration, high-precision nozzle offset calibration, visual calibration, and other functions.
The toolhead camera accessory package includes:
- Toolhead camera
- Fixing Screws ( x2 )
Applicable printer model
Bambu Lab X2D
When to replace
- The toolhead camera is damaged;
- The toolhead camera cable is damaged;
- The toolhead camera is nor responding and it has been identified that the camera is at fault;
Required Tools and Materials
- New toolhead camera
- H1.5 allen key
- Tweezers
Aviso de Segurança
⚠️ IMPORTANT!
It’s crucial to power off the printer before conducting any maintenance work, including work on the printer’s electronics and tool head wires. Performing tasks with the printer on can result in a short circuit, leading to electronic damage and safety hazards.
During maintenance or troubleshooting, you may need to disassemble parts, including the hotend. This exposes wires and electrical components that could short circuit if they contact each other, other metal, or electronic components while the printer is still on. This can result in damage to the printer’s electronics and additional issues.
Therefore, it’s crucial to turn off the printer and disconnect it from the power source before conducting any maintenance. This prevents short circuits or damage to the printer’s electronics, ensuring safe and effective maintenance. For any concerns or questions about following this guide, we recommend submitting a chamado técnico relatando o seu problema. and we will do our best to respond promptly and provide the assistance you need.
Video Guide
Remove the toolhead camera
Passo 1. Remove the toolhead rear cover
Use the H1.5 allen key to remove the 4 screws and take off the toolhead rear cover.

Passo 2. Disconnect the cables
-
Disconnect the right hotend fan cable, then open the locking tab of the toolhead camera FPC cable.

-
Use tweezers to loosen the FPC cable.

Passo 3. Remove the toolhead camera
-
Refer to the image below and on how to pry open the camera cover on the toolhead.

-
Use the H1.5 allen key to remove the 2 screws.

-
Carefully move the camera and FPC cable outward to remove the toolhead camera.

Install the toolhead camera
Passo 1. Install the toolhead camera
-
Push the toolhead camera FPC cable through the gap beneath the toolhead towards the connector position.

-
Align the camera bracket with the screw holes, then use the H1.5 allen key to tighten the 2 fixing screws.

-
Install the camera cover.

Passo 2. Connect the cables
-
Insert the toolhead camera FPC cable into the connector, ensuring alignment before securing the locking tab.

-
Connect the right hotend fan cable.

Passo 3. Install the toolhead rear cover
Use the H1.5 allen key to tighten the 4 fixing screws.

Verifying Success
✅ Connect the power supply, turn on the printer, and no related error message appears.
If you encounter any issues, please retrace your steps and check all connections before trying again. If the problems persist, please contact the Bambu Lab service team for further assistance.
Notas Finais
We hope this guide has provided clear and practical support.
If the issue remains unresolved, please submit a support ticket and include your recent printer logs and additional pictures or other details. Our technical team will review your request and provide detailed assistance.
You can also visit Bambu AI, which can instantly answer common questions and provide you with operational guidance.
