Door Sensor Replacement Guide for the P2S/X2D
Bambu Lab P2S • Série Performance P2
Door Sensor Replacement Guide for the P2S/X2D
Front Door Sensor
The front door sensor is a small circuit board mounted on the inside of the front column of the printer to sense the opened or closed status of the glass front door of the P2S.

The replacement Door Sensor package contains:
- One front door sensor circuit board
- One ST2x3.5 screw
Note: The cable is not included with this accessory, and if the cable is found to be damaged, a printer wire package is required to provide a cable for replacement.
When to Use This Guide
- When the door detection fails or always shows the door as open even when it is physically closed and when the door sensor cable is undamaged.
Tools and Materials Required
- Replacement front door sensor
- H1.5 Allen key
Aviso de Segurança
IMPORTANT!
Always power off and disconnect power on the printer before performing maintenance work. Not doing so means there is a risk of electric shock, short circuit, and damage to the printer or surrounding area.
When a maintenance task necessitates the printer being powered on, use insulated gloves for safety and pay special care not to pinch, damage, or put pressure on any exposed wires, connectors, or circuit boards. Additionally, the nozzle can be extremely hot so never touch it with exposed skin.
If you have any questions or concerns related to the above or the steps in this guide, please open a new ticket in our Support Page for assistance.
Check the Magnet in the Front Glass Door Handle.
Passo 1 – Remove the Handle
Open the front door. Using an H2.0 hex key, remove the two screws securing the handle. The handle will then come off naturally.

Passo 2 – Check the Magnet
If the square magnet is missing or cannot be secured due to damage to the handle, please replace it with a new handle.

Removing the Door Sensor
Passo 1: Remove the Door Sensor Screw
Open the glass front door, locate the door sensor board behind the right door frame, and remove the screw using the H1.5 Allen key.

Passo 2: Remove the Black Tape
Gently pull back the silicone strip lining the door frame and remove the black tape on the door sensor (set this tape aside to reuse if desired).

Passo 3: Remove the Door Sensor
Disconnect the cable from the door sensor board and remove the old door sensor board from the printer.

Installing the Door Sensor
Passo 1: Connect the Cable
Connect the cable to the replacement door sensor board.

Passo 2: Install the Door Sensor
Align the door sensor board with the screw hole and use the H1.5 Allen key to replace the screw.

Passo 3: Replace the Black Tape
Gently pull back the silicone strip and replace the black tape around the door sensor board.


Verifying Functionality
The door sensor is only effective while the printer is in use. During a test print, open the glass front door of the printer and confirm if the “door open” prompt pops up. Then close the door and confirm that the prompt disappears.
Notas Finais
We hope this guide has provided clear and practical support.
If the issue remains unresolved, please submit a support ticket and include your recent printer logs and additional pictures or other details. Our technical team will review your request and provide detailed assistance.
You can also visit Bambu AI, which can instantly answer common questions and provide you with operational guidance.
