Front Door Sensor

The front door sensor is a small circuit board mounted on the inside of the front column of the printer to sense the opened or closed status of the glass front door of the P2S.
fac173.jpg

The replacement Door Sensor package contains:

  1. One front door sensor circuit board
  2. One ST2x3.5 screw

Note: The cable is not included with this accessory, and if the cable is found to be damaged, a printer wire package is required to provide a cable for replacement.

When to Use This Guide

  • When the door detection fails or always shows the door as open even when it is physically closed and when the door sensor cable is undamaged.

Tools and Materials Required

  1. Replacement front door sensor
  2. H1.5 Allen key

Aviso de Segurança

IMPORTANT!

Always power off and disconnect power on the printer before performing maintenance work. Not doing so means there is a risk of electric shock, short circuit, and damage to the printer or surrounding area.

When a maintenance task necessitates the printer being powered on, use insulated gloves for safety and pay special care not to pinch, damage, or put pressure on any exposed wires, connectors, or circuit boards. Additionally, the nozzle can be extremely hot so never touch it with exposed skin.

If you have any questions or concerns related to the above or the steps in this guide, please open a new ticket in our Support Page for assistance.

Check the Magnet in the Front Glass Door Handle.

Passo 1 – Remove the Handle

Open the front door. Using an H2.0 hex key, remove the two screws securing the handle. The handle will then come off naturally.
2_screws_002.png

Passo 2 – Check the Magnet

If the square magnet is missing or cannot be secured due to damage to the handle, please replace it with a new handle.
remove_the_handle_003.png

Removing the Door Sensor

Passo 1: Remove the Door Sensor Screw

Open the glass front door, locate the door sensor board behind the right door frame, and remove the screw using the H1.5 Allen key.

02_002.png

Passo 2: Remove the Black Tape

Gently pull back the silicone strip lining the door frame and remove the black tape on the door sensor (set this tape aside to reuse if desired).

03_003.png

Passo 3: Remove the Door Sensor

Disconnect the cable from the door sensor board and remove the old door sensor board from the printer.

04_004.png

Installing the Door Sensor

Passo 1: Connect the Cable

Connect the cable to the replacement door sensor board.

05_005.png

Passo 2: Install the Door Sensor

Align the door sensor board with the screw hole and use the H1.5 Allen key to replace the screw.

07_007.png

Passo 3: Replace the Black Tape

Gently pull back the silicone strip and replace the black tape around the door sensor board.

08_008.png

09_009.png

Verifying Functionality

The door sensor is only effective while the printer is in use. During a test print, open the glass front door of the printer and confirm if the “door open” prompt pops up. Then close the door and confirm that the prompt disappears.

Notas Finais

We hope this guide has provided clear and practical support.
If the issue remains unresolved, please submit a support ticket and include your recent printer logs and additional pictures or other details. Our technical team will review your request and provide detailed assistance.
You can also visit Bambu AI, which can instantly answer common questions and provide you with operational guidance.