Filament Sensor

The Filament Sensor on the PrintTool is used to detect whether the filament is inserted into or ejected from the PrintTool. When the filament is inserted into the PrintTool, the magnet rocker arm moves closer to the sensor, thereby indicating that the filament has been inserted.

Possible Failures

  • The magnet rocker arm is stuck and cannot rebound.

  • Magnet falls off

  • There is sensor failure

Required Tools

  • H1.5 Allen Key

  • H2.0 allen key

Safety Tips

Before performing any maintenance on the printer and its electronic components (including the toolhead cable), turn off the printer and disconnect the power supply to prevent accidental screen touches or short circuits, which could cause additional electronic damage and safety hazards.
When performing maintenance or troubleshooting on your printer, please first check the temperature of the hotend and heatbed. Avoid operating at high temperatures. If operating at high temperatures is unavoidable, wear insulated gloves to ensure safe and effective maintenance.

Troubleshooting Steps

Passo 1. Fault Confirmation

Place the current PrintTool and wait for it to cool down.

20261030b-001.png

When the nozzle temperature drops to around 26°C, remove the left and right AMS Magnetic Panels and take out the Print Tool.

20261030b-002.png 20261030b-003.png

Press the black retaining clip on the print head, gently push the filament tube forward, and then pull it outwards.

20261030b-004.webp

Insert the filament tube into the side hole for later use.

20261030b-005.png

Use a piece of filament and observe the display changes on the AMS page after inserting/ejecting it.

20261030b-006.png

If the line becomes solid after insertion and dashed after ejection, the sensor is working correctly.

20261030b-007.png 20261030b-008.png

If the line does not change after inserting or ejecting the filament, proceed with further troubleshooting.

Passo 2. Fault Diagnosis

Turn off the printer, loosen the three screws securing the hotend, and remove the hotend.

20261030b-009.png

Loosen the four screws securing the front cover of the PrintTool and remove the front cover.

20261030b-010.png

Loosen the two screws securing the PrintTool circuit board.

20261030b-011.png

Carefully fold back the PrintTool circuit board and check if the square magnet on the rocker arm has fallen off.

If the magnet has fallen off, you need to replace the PrintTool Base.

20261030b-012.png

If the rocker arm cannot rebound, you can unscrew the screws fixing the rocker arm, check for internal debris, and ensure the rocker arm rebounds properly.

20261030b-013.png 20261030b-014.png

After ensuring the rocker arm is in normal condition, reassemble the PrintTool and test again. If the fault persists, it may be a sensor failure, and the PrintTool Base needs to be replaced.

Notas Finais

We hope this guide has provided clear and practical support.
If the issue remains unresolved, please submit a support ticket and include your recent printer logs and additional pictures or other details. Our customer support team will review your request and provide detailed assistance.
You can also visit Bambu AI, which can instantly answer common questions and provide you with operational guidance.