Substituição Purifier Power Supply
Bambu Lab H3C • Série Industrial H3
Substituição Purifier Power Supply
E1 Power Supply

When to Replace
- The device does not respond when connected to power and fails to power on normally.
- The device restarts automatically.
Safety Tips
Before performing any maintenance on the air purifier and its electronic components, power off the device and disconnect the power supply to prevent circuit shorts, which can cause additional device damage and safety risks. Before maintenance or troubleshooting, please ensure that the relevant parts have cooled down.
Tools and Materials
- H2.0 Allen key
Remove the E1 Power Supply
Passo 1. Remove the Filter Element
Disconnect the air duct connected to the purifier, the Power Cable, and the 6-pin cable (if any).

Slide the rear cover upwards to remove it.

Remove the air filter handle, pinch it, and pull out the air filter.

Passo 2. Separate the Front and Rear Housings
Peel off the three foam strips shown.
![]() |
![]() |
![]() |
Turn the device over and remove the footpads from the front housing.

Use an H2.0 Allen key to remove two screws.

Use an H2.0 Allen key to remove the seven screws as shown.

Separate the front and rear housings, then disconnect the connecting cables between them.

Passo 3. Remove the E1 Power Supply
Before proceeding, confirm that the device’s power cable is disconnected. Wait at least 1 minute after disconnecting the power before proceeding with the next steps.
Remove the power output cable from the cable management channel.
Use an H2.0 Allen key to remove the two screws.

Lift out the power supply and open the E1 power supply housing.

Disconnect the power input plug, and remove the E1 power supply module.

Note: The power plug has a locking tab. You need to press the locking tab as shown in the diagram before pulling it out. Do not pull forcefully.
Install the E1 Power Supply
Passo 1. Install the E1 Power Supply
Open the power supply housing and connect the power input plug. The two black cables can be connected in either order. Then close the power supply housing, ensuring that the cables are not pinched.

Reinstall the power supply in its original position and tighten the two screws using an H2.0 Allen key.

Arrange the power output cables.

Passo 2. Install the Front and Rear Housings
Connect the three plugs as shown, then close the front and rear housings.

Use an H2.0 Allen key to secure the seven screws.

Turn the device upside down and use an H2.0 Allen key to secure two screws.

Attach the footpads.

Attach the foam strips around the air filter.

Passo 3. Install the Filter Element
Install the filter element, ensuring the handle side faces outwards.

Tuck the air filter handle into the filter mesh to avoid obstructing the rear cover installation.

Install the rear cover.

Reinstall the purifier air duct, Power Cable, and 6-pin cable (if any).

Verify Functionality
After completing the replacement, connect the power and start the device. Confirm that it powers on normally and operates stably. Check that the display, buttons, and fan speed settings respond normally, with no unexpected power interruptions, automatic restarts, or error messages.
Notas Finais
We hope this guide has provided clear and practical support.
If the issue remains unresolved, please submit a support ticket and include your recent printer logs and additional pictures or other details. Our customer support team will review your request and provide detailed assistance.
You can also visit Bambu AI, which can instantly answer common questions and provide you with operational guidance.




