X3508 Extruder Servo Motor

The X3508 extruder servo motor used in the P2S is a high-precision servo motor developed by Bambu Lab. It accurately controls filament feeding, stopping, and retraction, making it a key component for ensuring print quality and success. The accessory package includes the extruder motor and mounting screws.
fam018_1.jpg

  1. X3508 Extruder servo motor* 1
  2. M2.5×5 screw* 2

When to Use This Guide

  • The extruder servo motor is damaged and is unable to function.

Required Tools and Materials

  1. New X3508 extruder servo motor
  2. M2.5×5 screw* 2
  3. H2.0 Allen key
  4. H1.5 Allen key

Aviso de Segurança

IMPORTANT!

Always power off and disconnect power on the printer before performing maintenance work. Not doing so means there is a risk of electric shock, short circuit, and damage to the printer or surrounding area.

When a maintenance task necessitates the printer being powered on, use insulated gloves for safety and pay special care not to pinch, damage, or put pressure on any exposed wires, connectors, or circuit boards. Additionally, the nozzle can be extremely hot so never touch it with exposed skin.

If you have any questions or concerns related to the above or the steps in this guide, please open a new ticket in our Support Page for assistance.

Remove the Extruder Servo Motor

Passo 1: Remove the Toolhead Housing

Please refer to the wiki: Replace the Toolhead Housing for instructions on removing the toolhead housing.
 
toolhead_housing_001.png

Passo 2: Remove the Extruder

Please refer to the wiki: Replace extruder components for instructions on removing the extruder.
 
remove_extruder_003.png

Passo 3: Remove the TH board

Please refer to the wiki: Replace the Toolhead Circuit Board for instructions on removing the TH board.
 
th_board_removed_004.png

Passo 4: Remove the Extruder Servo Motor

Use an H2.0 Allen key to remove the two extruder servo motor fixing screws (M2.5×5), and then remove the 3508 extruder servo motor from the toolhead.

Install the Extruder Servo Motor

Passo 1: Install the Extruder Motor

Refer to the installation orientation in the figure below (with the extruder servo motor cable facing left), and install the extruder servo motor onto the toolhead. Then, use an H2.0 Allen key to tighten the two M2.5×5 mounting screws.

Note: Please hold the extruder servo motor with your hand to prevent it from falling.

Passo 2: Install the TH board

Please refer to the wiki: Replace the Toolhead Circuit Board for instructions on installing the TH board.
 
th_board_installed_005.png

Passo 3: Install the Extruder

Please refer to the wiki: Replace extruder components for instructions on installing the extruder.
 
extruder_installed_004.png

Passo 4: Install the Toolhead Housing

Refer to the wiki: Replace the Toolhead Housing for instructions on installing the toolhead housing.
 
close_front_cover_002.png

Verifying Functionality

Connect the power supply, turn on the printer, and check if the extruder can extrude filament normally.

If you encounter any problems, retrace your steps and ensure that all connections are secure before trying again. If the problem persists, contact the Bambu Lab technical support for further assistance.

Notas Finais

We hope this guide has provided clear and practical support.
If the issue remains unresolved, please submit a support ticket and include your recent printer logs and additional pictures or other details. Our technical team will review your request and provide detailed assistance.
You can also visit Bambu AI, which can instantly answer common questions and provide you with operational guidance.