Purge Wiper Assembly

The purge wiper assembly is installed above the printer’s inner frame and is used to eject the purged filament generated during filament changes.
fac162.jpg

When to Use This Guide

When the purge wiper assembly is damaged.

Required Tools and Materials

  • New purge wiper assembly
  • H2.0 hex wrench

Aviso de Segurança

IMPORTANT!

Always power off and disconnect power on the printer before performing maintenance work. Not doing so means there is a risk of electric shock, short circuit, and damage to the printer or surrounding area.

When a maintenance task necessitates the printer being powered on, use insulated gloves for safety and pay special care not to pinch, damage, or put pressure on any exposed wires, connectors, or circuit boards. Additionally, the nozzle can be extremely hot so never touch it with exposed skin.

If you have any questions or concerns related to the above or the steps in this guide, please open a new ticket in our Support Page for assistance.

Removing the Purge Wiper

Passo 1: Remove the Rear Panel

Refer to this guide to remove the PTFE tube bracket, buffer, and rear panel: Replacement of P2S Rear Panel

Passo 2: Release Cables

Release the cable clips and remove the cables to expose the two screws securing the purge wiper assembly.

release_cables002.jpg

Passo 3: Remove the Purge Wiper Assembly

Use an H2.0 hex wrench to remove the two screws securing the purge wiper assembly, then take the assembly out from inside the printer.

remove_the_purge_wiper003.jpg

Installing the Purge Wiper Assembly

Passo 1: Position the Purge Wiper Assembly

Install the purge wiper assembly onto the printer’s inner frame, holding it by hand to ensure its top surface is flush with the inner frame’s top surface.

ensure_parallelism004.jpg

Passo 2: Install the Purge Wiper Assembly

From the back of the printer, install the two screws securing the purge wiper assembly. Keep holding the assembly with your hand to ensure it remains flush with the printer’s inner frame.

install_the_purge_wiper005.jpg

Passo 3: Install the Cables

Secure the cables into the cable clips.

install_cables006.jpg

Passo 4: Install the Back Panel

Refer to this Wiki to reinstall the rear panel, buffer and PTFE tube bracket: Replacement of P2S Rear Panel

Verifying Success

Connect the printer to power, turn it on, and run a filament change or loading operation to confirm it completes successfully.

Notas Finais

We hope this guide has provided clear and practical support.
If the issue remains unresolved, please submit a support ticket and include your recent printer logs and additional pictures or other details. Our technical team will review your request and provide detailed assistance.
You can also visit Bambu AI, which can instantly answer common questions and provide you with operational guidance.