Cable Chain Replacement Guide for the P2S
Bambu Lab X2D • Série Avançada X2
Cable Chain Replacement Guide for the P2S
Cable Chain
🔎 Find the P2S Cable Chain in the Bambu Lab store.
The cable chain is a mechanical component connected between the toolhead and the rear of the printer, used to organize and protect the toolhead cables and PTFE tubes.

When to Use This Guide
- The cable chain is cracked or broken
- The base of the cable chain is damaged and cannot be secured
Required Tools and Materials
- New Cable chain assembly
Aviso de Segurança
IMPORTANT!
Always power off and disconnect power on the printer before performing maintenance work. Not doing so means there is a risk of electric shock, short circuit, and damage to the printer or surrounding area.
When a maintenance task necessitates the printer being powered on, use insulated gloves for safety and pay special care not to pinch, damage, or put pressure on any exposed wires, connectors, or circuit boards. Additionally, the nozzle can be extremely hot so never touch it with exposed skin.
If you have any questions or concerns related to the above or the steps in this guide, please open a new ticket in our Support Page for assistance.
Remove the Cable Chain
Passo 1: Remove the Toolhead Front Cover
To facilitate removal of the PTFE tube, first remove the toolhead front cover (you do not need to disconnect the wiring).

Passo 2: Remove the PTFE Tube
Press the button on the pneumatic connector of the extruder cover to release the PTFE tube. Then you may close the toolhead front cover.

Next, pull the PTFE tube out of the cable chain clip.

Passo 3: Remove the Chain Clips
Unfasten the clips installed on the cable chain and remove them from the chain.

Passo 4: Remove the Cable Chain
Disconnect the cable chain from its base.

Remove the USB-C data cable from inside the chain.

Separate the segment of chain connected to the AP board cover (retain two sections on the AP board cover).

Install the Cable Chain
Passo 1: Install the Cable Chain
Position the closed side of the cable chain facing outward, then connect the chain to the AP board cover’s trailing section.

Insert the USB-C data cable (and MC-TH cable) into the chain.

Attach the chain to its base.

Passo 2: Install the Chain Clips
Attach the chain clips at the 12th section of the cable chain (counting from the toolhead side).

Passo 3: Reinstall the PTFE Tube
Insert the PTFE tube through the clip holes, and reconnect it to the extruder pneumatic fitting.

Removing the Cable Chain Base
Passo 1: Disconnect the Cable Chain
Detach the chain from its base bracket, partially remove the USB-C and MC-TH cables to facilitate base removal.

Passo 2: Remove the Base Bracket
Pull out the base bracket, removing it from around the USB-C cable.

Installing the Cable Chain Base
Passo 1: Wire Routing
Lay the USB-C cable into the notch in the cable chain base.

Passo 2: Install the Base Bracket
Mount the base bracket in place with the opening facing right, and secure the USB-C cable properly.

Passo 3: Reattach the Cable Chain
Mount the cable chain back onto the base.

Verifying Success
Check that the toolhead cables and PTFE tubing do not protrude outside the chain, and that the toolhead moves normally.
Notas Finais
We hope this guide has provided clear and practical support.
If the issue remains unresolved, please submit a support ticket and include your recent printer logs and additional pictures or other details. Our technical team will review your request and provide detailed assistance.
You can also visit Bambu AI, which can instantly answer common questions and provide you with operational guidance.
