Chamber Temperature Sensor

🔎 Find the X2D Chamber Temperature Sensor in the Bambu Lab store.

The chamber temperature sensor is a temperature sensor with a fixed bracket installed inside the printer’s front beam, used to detect the internal temperature of the printer chamber.

Applicable printer model

Bambu Lab X2D

When to Replace

  1. The chamber temperature sensor wire is damaged.
  2. Chamber temperature error.

Required tools and materials

  • H2.0 allen key
  • New chamber temperature sensor

Aviso de Segurança

⚠️ IMPORTANT!

It’s crucial to power off the printer before conducting any maintenance work, including work on the printer’s electronics and tool head wires. Performing tasks with the printer on can result in a short circuit, leading to electronic damage and safety hazards.

During maintenance or troubleshooting, you may need to disassemble parts, including the hotend. This exposes wires and electrical components that could short circuit if they contact each other, other metal, or electronic components while the printer is still on. This can result in damage to the printer’s electronics and additional issues.

Therefore, it’s crucial to turn off the printer and disconnect it from the power source before conducting any maintenance. This prevents short circuits or damage to the printer’s electronics, ensuring safe and effective maintenance. For any concerns or questions about following this guide, we recommend submitting a chamado técnico relatando o seu problema. and we will do our best to respond promptly and provide the assistance you need.

Video Guide

Remove the old chamber temperature sensor

Passo 1. Unlock the chamber temperature sensor

Remove the top glass cover, open the glass front door, locate the chamber temperature sensor behind the front cover,

002_find_chamber_sensor.png

Use the H2.0 allen key to remove the two screws securing the sensor bracket.

003_chamber_sensor_screws.png

Passo 2. Remove the chamber temperature sensor

Disconnect the connector beside it and remove the chamber temperature sensor.
004_disconnect_chamber_sensor.png

Install the new chamber temperature sensor

Passo 1. Connect the chamber temperature sensor

Plug the chamber temperature sensor into the connector

004_disconnect_chamber_sensor.png

Passo 2. Install the chamber temperature sensor

Place the chamber temperature sensor with the inclined surface facing inward at the installation position, align the screw holes, use the H2.0 allen key to secure two screws.

When tightening the first screw, hold the chamber temperature sensor by hand; after both screws are in place, tighten them uniformly.

Verifying Success

✅ Connect the power and turn on the printer, check and confirm that the printer chamber temperature is displayed normally and the value is close to the current chamber temperature.

Notas Finais

We hope this guide provides you with clear and practical assistance.
If the issue persists, please submit a service ticket with your recent printer logs, related photos, or other details. Our technical team is ready to assist you and provide support.
You can also visit Bambu AI, which instantly answers common questions and offers operational guidance.