Nozzle Offset Calibration Sensor Replacement Guide for the X2D.
Bambu Lab X2D • Série Avançada X2
Nozzle Offset Calibration Sensor Replacement Guide for the X2D.
Nozzle Offset Calibration Sensor
🔎 Find the X2D Nozzle Offset Calibration Sensor in the Bambu Lab store.
The nozzle offset calibration sensor is installed behind the heatbed to calibrate the positions of the two hotends, ensuring high-quality printing.

Applicable printer model
X2D
When to Replace
- When the two nozzles are misaligned, it can cause layer shifts during printing that cannot be corrected through nozzle offset calibration.
- Official confirmation from Bambu Lab technical support indicates that the nozzle offset calibration sensor needs to be replaced.
tools and Materials Required
- A new nozzle offset calibration sensor
- H1.5 allen key
- H2.0 allen key
Aviso de Segurança
⚠️ IMPORTANT!
It’s crucial to power off the printer before conducting any maintenance work, including work on the printer’s electronics and tool head wires. Performing tasks with the printer on can result in a short circuit, leading to electronic damage and safety hazards.
During maintenance or troubleshooting, you may need to disassemble parts, including the hotend. This exposes wires and electrical components that could short circuit if they contact each other, other metal, or electronic components while the printer is still on. This can result in damage to the printer’s electronics and additional issues.
Therefore, it’s crucial to turn off the printer and disconnect it from the power source before conducting any maintenance. This prevents short circuits or damage to the printer’s electronics, ensuring safe and effective maintenance. For any concerns or questions about following this guide, we recommend submitting a chamado técnico relatando o seu problema. and we will do our best to respond promptly and provide the assistance you need.
Remove the Old Nozzle Offset Calibration Sensor
Passo 1. Adjust the Heatbed Position
On the screen, click “Motion XYZ”, then tap “Toolhead Homing”.
![]() |
![]() |
After the toolhead finishes homing, tap the “Heatbed Up 10” icon once more.

Passo 2. Remove the Nozzle Offset Calibration Sensor
Remove the TWO screws of the nozzle offset calibration sensor.

Disconnect the cable of the nozzle offset calibration sensor by pressing the cable’s locking tab with a screwdriver, then removing the cable.
![]() |
![]() |
Install the Nozzle Offset Calibration Sensor
Connect the cable of the nozzle offset calibration sensor.
![]() |
![]() |
Install the two screws of the nozzle offset calibration sensor.

Remove the Nozzle Wiping Plate
Remove the single screw on the right side of the nozzle offset calibration sensor, then gently remove the Nozzle Wiping Plate.

Install the Nozzle Wiping Plate
Install the Nozzle Wiping Plate on the right side of the nozzle offset calibration sensor, then secure it with the single screw.

Verifying Success
✅ Connect the power and turn on the printer. Start a print; if no errors occur, the installation is successful.
Notas Finais
We hope this guide has provided clear and practical support.
If the issue remains unresolved, please submit a support ticket and include your recent printer logs and additional pictures or other details. Our technical team will review your request and provide detailed assistance.
You can also visit Bambu AI, which can instantly answer common questions and provide you with operational guidance.






